We offer DC / DC Units in the following variations We build Special purpose SMPS units based on your requirements mail us at sales@nhpelectronics.com Click Here to send your enquiry now
|
BATTERY CHARGERS
MODEL NO: BC 24V 10A - Download PDF
BATTERY CHARGER FOR ENGINE START APPLICATIONS 24V-10 AMPERES SUITABLE FOR CHARGING 24VOLTS 100/130/180AH BATTERIES
Click on Image to Enlarge
SPECIFICATIONS Input Voltage 170-270 V AC Output voltage Float Mode 26.2 V DC Boost Mode 27.4 to 28 V DC Inrush Current Limited by NTC Thermister Charging current in boost mode 10 amps Charging current in float mode 0 to 3.5 amps Operating Temperature 0 TO 50 DEG C Leakage current <2 mA at 230 vac Vibration 10-500 Hz 2G 10 min/1cycle 60 mins each along XYZ axis Protections Input under voltage Cutoff level 140 VAC. Turn on voltage 160 VAC Input over voltage 300 V AC units shuts off if voltage goes above this value Output over voltage (Batt charger included) 29.5 V DC Output short circuit and overload Continuously protected Battery reverse polarity Protected both on line and off line Current drawn by charger from battery Draws zero current from the battery under any circumstances Externally Induced Over voltage Protected against output overvoltage caused by parallel connection of alternator etc Annunciation Potential free NO /NC contact for charger On/ Fail indication Indication Mains On, Float, Boost, and Battery Reverse Line Regulation <1% Load regulation <1% Ripple and noise 150 mv p-p Isolation between: Input & Output 2000V AC Input & Earth 1500V AC Output & Earth 1500V AC Dimensions: L*B*H 190*155*75mm Mounting Wall mounting type Weight 1500 gms
